Facing of facades simultaneously with a laying is made by an obverse brick, ceramic, silicate and tonkopilenymi plates from a natural stone.
Plates from a natural stone
On the levelled horizontal basis put a cement mortal, stack fixed by anchors on the back party of a laying angular and majachnye plates. Establish intermediate plates of the first row on the tense berthing cord. It is simultaneously carried out zadelka the ends armaturnoj a wire, welded on a steel plate. The anchor plate is attached to an inside of a facing plate epoksidnym by glue, and the wire ends are closed up in a laying. Such way provides reliable connection of facing with a wall laying.
Facing plates are established with bandaging of seams or a seam in a seam. Facing of walls begin with interfloor overlapping of a basic G-shaped number of the facing plates which are closed up in a laying. After that ordinary flat plates which are attached to a wall are established. .
If the thickness of a plate is more 40 mm a facing number should be put earlier, than the laying, on height of some facing will start to be carried out. At a smaller thickness before an establishment of a facing plate the laying on plate height at first is carried out.
Ceramic or silicate plates
At plate facing are fixed prokladnymi by numbers and a laying carry out in the same sequence, as in the way described above.
A Number prislonnyh plates is established after packing prokladnogo a number. Then start to spread a wall to level prislonnyh plates. After that start packing prokladnogo of some facing. .
Horizontal seams between top prislonnyh and prokladnyh plates are filled after full building deposits. .
the Brick or a stone with the various invoice and colour
Facing make, as a rule, ceramic bricks and stones. Bandaging is carried out tychkovymi by numbers through three spoon.
Facing butovoj layings a brick or stones of the correct form
Facing butovoj layings is carried out by a brick or stones of the correct form through everyone four-five lozhkovyh numbers. Thus the height should not exceed 0,6 m. Bandaging of a facing plate with other part of a laying is carried out tychkovymi by numbers. Horizontal seams should coincide with tychkovymi facing numbers.